Informacja

Drogi użytkowniku, aplikacja do prawidłowego działania wymaga obsługi JavaScript. Proszę włącz obsługę JavaScript w Twojej przeglądarce.

Tytuł pozycji:

Influence of microstructure on fatigue fracture of Ti–2.5Cu alloy

Tytuł:
Influence of microstructure on fatigue fracture of Ti–2.5Cu alloy
Autorzy:
Hepner, M.
Rozumek, D.
Data publikacji:
2018
Słowa kluczowe:
titanium alloy
microstructure
heat treatment
fatigue fracture
stopy tytanu
mikrostruktura
obróbka cieplna
pękanie zmęczeniowe
Język:
angielski
Dostawca treści:
BazTech
Artykuł
  Przejdź do źródła  Link otwiera się w nowym oknie
The paper presents the test results obtained for fatigue crack growth in Ti–2.5Cu alloy subjected to bending in notched specimens. The tested specimens were subjected to various variants of heat treatment. The tests were performed at the fatigue test stand MZGS-100 under loading frequency 28.4 Hz. The study was conducted for a constant amplitude of moment Ma = 11.2 N∙m and different values of stress ratio R = –1 and 0. Influence of the microstructure on the crack paths in plane specimens was observed. The propagation of the main crack in the two-phase structure takes place both transcrystallinely through α phase grains and through the boundaries of the grains in metastable phase precipitation areas, whereas the propagation of the side cracks takes place along the precipitates of the coniferous phase. In the material after supersaturation and ageing at a temperature of 415°C, after Nf = 12 000 cycles (R = 0), no side cracks were observed, and the main crack develops in both phases that form the microstructure shown in Figure 10. A different fracture mechanism occurs for the material after supersaturation and ageing (Nf = 11 000 cycles) at a temperature of 760°C. In this case, an irregular path of the main crack is observed, whose direction in the micro-areas is determined by the precipitates of the intermetallic phase (Fig. 11). From the beginning of the main crack and along its entire length, numerous side cracks develop that are over 150 μm in length. The components of the structure that facilitate the propagation of cracks and determine their direction are clusters of Ti2Cu precipitates on the boundaries of α phase. In case of this alloy, the impact of the mean stress value during cyclic testing decreases fatigue life considerably.
Celem pracy była ocena trwałości zmęczeniowej stopu Ti–2,5Cu (IMI230) po różnej obróbce cieplnej oraz określenie różnic w mechanizmie propagacji pęknięć zmęczeniowych uwarunkowanych odmienną mikrostrukturą.
Opracowanie rekordu w ramach umowy 509/P-DUN/2018 ze środków MNiSW przeznaczonych na działalność upowszechniającą naukę (2018).

Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies